Pressure Washing Prices in San Francisco (2026)
San Francisco pressure washing prices typically run 30–40 percent above national benchmarks: a full house soft wash runs roughly $325–$840, wood decks land near $195–$490, and where driveways exist — outer neighborhoods, the west side, single-family pockets — a 600–1,000 sq ft slab most often quotes $155–$365. This is a high-cost metro where the job itself is different too: a rowhouse city of Victorians, stoops and sidewalk frontage rather than sprawling flatwork, with fog that keeps shaded walls damp enough to grow mildew and housing old enough that lead-safe practices are part of the professional baseline.
By the MowMath editorial team · Updated $1
Key numbers at a glance
| Job | Typical San Francisco range (2026) | Notes |
|---|---|---|
| Driveway (600–1,000 sq ft) | $155–$365 | West side and single-family pockets; oil and grime common |
| House wash (1,500–2,500 sq ft siding) | $325–$840 | Soft wash; older siding and paint need gentle chemistry |
| Driveway + house bundle | $455–$1,050 | Best per-hour value; same stop, same setup |
| Wood deck (200–400 sq ft) | $195–$490 | Lower PSI; fog-damp timber grows algae fast |

Pressure washing prices in San Francisco: the ranges
The national benchmarks this site uses are $120–$260 for a driveway, $250–$600 for a house wash and $150–$350 for a deck. San Francisco sits in the very high cost band, so those figures typically shift up 30–40 percent. The mix skews away from driveways toward facades, stoops, steps and small patios — rowhouse frontage prices by the elevation, not the slab — and the surfaces doing the work are old: wood siding that has taken a century of weather, soft brick and mortar, and paint that may predate the 1978 federal lead-paint cutoff. Every number below is a hedged range for planning, not a surveyed price.
| Job | Typical San Francisco range (2026) | Notes |
|---|---|---|
| Driveway (600–1,000 sq ft) | $155–$365 | West side and single-family pockets; oil and grime common |
| House wash (1,500–2,500 sq ft siding) | $325–$840 | Soft wash; older siding and paint need gentle chemistry |
| Driveway + house bundle | $455–$1,050 | Best per-hour value; same stop, same setup |
| Wood deck (200–400 sq ft) | $195–$490 | Lower PSI; fog-damp timber grows algae fast |
| Patio / pavers + poly sand | $260–$630 | Small patios, courtyards and garage pads |
| Fence (linear ft) | $2.00–$4.90 / ft | Both sides priced separately |
Inside the metro, Pacific Heights and the north waterfront carry painted-lady facades where access, height and paint condition push quotes to the top of every band. The Sunset and Richmond districts run garage pads, backyard patios and fog-exposed siding that wash mid-band on density — the blocks are tight, so a crew can work multiple fronts on one street. Noe Valley, Bernal and the southern neighborhoods mix Victorians with post-quake rebuilds, and the farther south and west you go, the more the job starts to look like a conventional driveway-and-deck route. Downtown condo and storefront work buys mostly sidewalk and facade cleaning under building-management rules.

What moves prices in San Francisco
Climate, fog and mildew. Summer fog is the grime engine here. Gray stratus rolls in off the ocean, keeps north- and west-facing walls damp for hours, then burns off to sun — a cycle that repeats for months and grows algae and mildew on shaded siding, stairs and fence lines faster than the city's rainfall alone would suggest. Add wind-driven grime from busy arterial streets and the salt exposure of western neighborhoods, and a property here typically benefits from a wash every one to two years, with shaded fog-belt homes on the annual end of that range.
Housing age, siding and lead paint. Much of San Francisco's housing predates WWII — Victorians, Edwardians and post-1906 rebuilds with wood siding, soft brick and ornate trim that punish carelessness. High pressure on old siding strips paint, fuzzes wood and turns a wash into a repaint, so competent crews soft wash and let chemistry do the lifting. The lead question is real: professional work on pre-1978 painted surfaces falls under the EPA's Renovation, Repair and Painting rule (epa.gov/lead), which sets lead-safe work practices. Ask any provider directly about lead-safe practices before they point a wand at a painted Victorian — the answer separates professionals from rentals.
Labor, access and route math. The 30–40 percent premium over national benchmarks is mostly overhead — among the highest wages, fuel and commercial insurance in the country — plus access costs unique to the city: parking a rig on a blocked-off street, hauling hose up stoops and hillsides, and hopscotching between jobs that are close as the crow flies and slow as the traffic flows. What the city gives back is density: a crew that books one Sunset block can wash four fronts without moving the truck, which is why per-stop quotes inside dense neighborhoods can land softer than the headline band suggests.
Where the water goes. San Francisco is the only coastal city in California with a combined sewer system that collects and treats both wastewater and stormwater in the same pipe network, per the San Francisco Public Utilities Commission — so unlike most California cities, much of the runoff from a wash heads to treatment rather than straight to the bay. That does not make disposal a free-for-all: the SFPUC regulates what enters the system, and crews should verify current discharge and containment expectations for the specific site rather than improvise at the curb.
Questions worth asking any San Francisco provider:
- Soft wash or pressure on this siding? Old wood and painted surfaces should never see a close-range wand.
- How do you handle pre-1978 paint? Lead-safe practices are the professional answer on century-old paint.
- What is your wash-water plan on this slope? Hills send water downhill fast — containment should be part of the quote.
- Can you take the stoop and sidewalk with the facade? Bundled frontage work is where the ticket grows.
Stack these bands against the other 24 metros on the pressure washing prices by city hub, turn any surface into a defensible number with the pressure washing calculator, and compare the other half of the property budget on the lawn care prices in San Francisco page. The local band sets the market; the math keeps you honest inside it.

FAQ
How much does pressure washing cost in San Francisco?
San Francisco typically runs 30–40 percent above national benchmarks: roughly $155–$365 for a 600–1,000 sq ft driveway, $325–$840 for a full house soft wash, and $195–$490 for a wood deck. Big-metro labor, insurance and older surfaces set the floor.
How much does a house wash cost in San Francisco?
Roughly $325–$840 for 1,500–2,500 sq ft of exterior, soft wash with chemicals included. Fog-fed mildew on shaded walls is routine, and older Victorian and Edwardian siding wants gentle chemistry — plus lead-safe practices on any pre-1978 paint.
Is there driveway work in a rowhouse city like San Francisco?
Yes, but the mix shifts. Much of the city is rowhouses with stoops and sidewalk frontage rather than long driveways, so facade, stair and flatwork cleaning anchors the ticket, while Pacific Heights mansions, Sunset and Richmond district garages, and outer neighborhoods supply the driveway and patio work.
Can you pressure wash a painted Victorian in San Francisco?
Carefully, and usually with soft wash rather than pressure. Many painted ladies predate 1978, so disturbed paint can contain lead — the EPA Renovation, Repair and Painting rule applies to professional work on pre-1978 homes. Ask any provider about lead-safe practices before they spray.
Where does wash water go in San Francisco?
San Francisco is the only coastal city in California with a combined sewer system that collects and treats both wastewater and stormwater, per the SFPUC — so much of the city's runoff reaches a treatment plant rather than flowing straight to the bay. Crews should still verify disposal expectations with the SFPUC for the specific site.